ASP-primeStd

Concrete substrates to be coated must be sound and exhibit a minimum compressive strength of 25N/mm² and a minimum of 1.5N/mm² tensile strength for the application of the proposed system. The profile and levels must be appropriate for the application of the proposed system, capable of bearing loads, free of cracks and voids, and free from laitance, dust and other contamination. The substrate must be dry to 75% relative humidity and free from rising damp, ground water, oil, waxes, fats and other contamination. Should there be rising damp, ground water problems or impurities such as penetrated oils, etc., please refer to the ASP Technical Team for a suitable and appropriate substrate preparation guideline or solution. The substrate may be prepared by blasting, scarifying or diamond grinding to remove laitance. Irregularities, small damages and cracks must be repaired with an epoxy filler.

Mix Base A and Hardener B with a low-speed drill fitted with a spiral mixing blade for approximately 3 minutes to obtain a homogeneous mixture. Ensure excessive air is not introduced while mixing. The mixed material must be applied within 15 minutes at 20ºC. Apply immediately after mixing with a roller or double-lipped rubber squeegee, working the resin well into the substrate, permeating any surface irregularities. On porous substrates apply further resin until the substrate is completely wetted out. Avoid any ponding of the primer. Broadcast into the wet primer with a suitable size scatter aggregate to accommodate the specified top coat system. For more detailed information on substrate requirements and preparation, priming and application of the top coat, please refer to the product’s method statement.

Clean all spillages on ASP-primeStd immediately to maintain its appearance and lifespan. Clean the floor regularly with a rotary brush or mechanical scrubber and a suitable detergent. See how to clean and maintain a resin floor.

Applicators must use appropriate personal protective equipment. Dispose of used and empty packaging, solvents and washings in line with local environmental, health and safety by-laws. Refer to the product's material safety data sheet for detail.